![]() ![]() The Eddystone namespace ID cannot be entered directly in the RadBeacon configuration app. If you leave the URL blank, then it will broadcast iBeacon/Altbeacon and Eddystone UID. ![]() If you configure a URL to be broadcast, then it will broadcast iBeacon/AltBeacon and Eddystone URL. The RadBeacon Dot Eddystone beacon can be configured to advertise iBeacon/AltBeacon and either Eddystone UID or Eddystone URL. The RadBeacon USB Eddystone beacon can be configured to advertise any combination of iBeacon, AltBeacon, Eddystone UID, and Eddystone URL (although you must choose at least one). Occasionally, a configurable beacon cannot be contacted by the app on the first attempt, so you may need to try again. If it is not configurable, an alert is displayed after 15 seconds indicating that the beacon could not be contacted for configuration. If it is configurable, then the configuration detail screen for the beacon is displayed. Tap on the beacon you would like to configure. Potentially configurable Eddystone RadBeacons should be identified in the list with the Bluetooth device name "RadBeacon G". This scans for beacons for 5 seconds and displays all beacons found during the scan. To start scanning for beacons, press the SCAN button in the upper right corner on the action bar. The main beacon scan screen is displayed which should be empty. In order to start scanning for beacons, first launch the RadBeacon configuration app. For details see "How do I put beacons into configurable mode?" This can be done by power cycling the beacon. If you still aren't seeing the beacon then something maybe wrong with Bluetooth on your device and you can try clearing it's cache by turning Bluetooth off and then again.First make sure you beacons are in configurable mode. When you scan for the beacon, you should see it. For RadBeacon usb, remove power and restore power. If you are not seeing the RadBeacons in the app when you scan, the beacon is probably not in config mode anymore. On restart the problem should be corrected. If that doesn't fix it, try resetting your phone by holding down the sleep/wake button and the home button until the phone powers off. You should try turning off Bluetooth and then turning it back on again. Apple is aware of the problem and promising a fix. If you've cycled power to your beacon and are still unable to recognize it using the RadBeacon Config App, you may be experiencing the results of an iOS bug that affects proximity ranging. ![]() Re-initiating Configurable ModeĬonfigurable mode can be re-initiated for RadBeacon USB beacons by removing and restoring power to the device. If you are using the RadBeacon Config App to detect and configure your beacons, and are unable to recognize or access your beacons, it is likely that this configuration window has lapsed. ![]() Once your RadBeacon USB has been plugged in, or your RadBeacon Tag has been activated, the beacon will broadcast in configurable mode for an initial window of 30 minutes. You can scan for beacons by pulling down on the table view in the RadBeacon Configuration App.Äownload the RadBeacon Config App for your device. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |